Safety Operation Regulations for Electromagnetic Bridge Cranes

Electromagnetic bridge crane is a large bridge crane commonly used in steel workshops. It can be used to lift iron plates, steel bars, molds and other iron objects. The editor introduces the safe operation rules of electromagnetic bridge crane.

Operate electromagnetic bridge cranes to comply with safe operating regulations

1.  The relevant content of the "Safety Operating Regulations for Bridge Cranes" and this regulation should be strictly followed.
2.  When inspecting the car, cut off the power first, and put up a power failure sign to prevent accidental power supply.
3.  Before lifting, carefully check whether the performance of each part is good and whether the safety devices are complete and effective.
4.  It is strictly forbidden for electric disks to pass by people during operation, and it is strictly forbidden for anyone to walk around in the working area of electric disks.
5.  When the power is cut off, it must be close to the hopper and the hopper, and it is forbidden to put it in a long distance.
6.  When lifting materials excluding weight, lifting with sensors is not allowed.
7.  Adhere to the five no principles at work:
   1.  Do not hang if the load exceeds the load.
   2.  Objects buried in the ground shall not be hung.
   3. Do not hang if you don't know the weight.
   4.  The command signal is unclear, and do not hang in the event of wrong command.
   5. Unclear vision.
8.  Do not allow the electric disk to rotate during work to avoid damage to the wires and personal equipment accidents.
9.  After the work is finished, put the electric disk on a flat and dry ground and cut off the power supply.

The spreader of the electromagnetic bridge crane is a device that works with electricity, so be careful when using it.

共有Facebook

Tweet

フォ

保存